Please also be aware that the 5V terminal is for reference only and should not be used for powering other devices. In particular, please pay special attention to connection to the external motor power supply (VMS), as connecting it to the wrong terminal can result in the motor power supply being applied to a connected controller. Incorrect connections to this module can result in permanent damage to both module and connected electronic equipment. Please check that you have connected this motor drive module correctly before applying power to it. WARNING: IMPROPER USE OF THIS MOTOR DRIVE MODULE CAN RESULT IN DAMAGE TO BOTH THE MODULE AND ANY ELECTRONIC EQUIPMENT CONNECTED TO IT. This controller board can be purchased here. Control signal input voltage range: 4.5~5.5V (high) / 0V (low) The logical part of the operating current range: 0 ~ 36mA The logical part of the terminal supply voltage: 4.5~7V Driven part of the peak current Io: 2A per bridge Driven part of the terminal supply voltage: VMS 5~35V Driver: L298N Dual H Bridge DC Motor Driver IC Can easily control the DC motor speed and direction, can also control a 2-phase stepper motor Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface, power for 5V single-chip circuitry, support 3.3VMCU control
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |